Show RAID Controller Module NVSRAM

This command returns the NVSRAM byte values for the specified host type. If you do not enter the optional parameters, this command returns a list of all NVSRAM byte values.

Syntax

show (allRAID Controller Modules | RAID controller module [(a | b)]) NVSRAM [hostType=(hostTypeIndexLabel | host="hostName")]

Parameters

Parameter	Description
allRAID Controller Modules	Returns information about both RAID controller modules in the storage array.
(a | b)	Returns information about a specific RAID controller module in the storage array. Valid RAID controller module identifiers are a or b where a is the RAID controller module in slot A and b is the RAID controller module in slot B. Enclose the RAID controller module identifier in square brackets ([ ]).
hostTypeIndexLabel	The index label or number of the host type. Use the show storageArray hostTypeTable command to generate a list of available host type identifiers.
hostName	The name of the host connected to the RAID controller modules. Enclose the host name in double quotes (" ").

Notes

Use the show RAID controller module NVSRAM command to display parts or all of the NVSRAM before using the set RAID controller module command to change NVSRAM values.

Minimum Firmware Level

6.10