Set Physical Disk Service Action Allowed Indicator
This command turns on or turns off the Service Action Allowed indicator light on a physical disk in the FC-4 16x expansion enclosure. If the storage array does not support the Service Action Allowed indicator light feature, this command returns an error. If the storage array supports the command but is unable to turn on or turn off the indicator light, this command returns an error.
Syntax
set (physical disk [trayID,slotID] | physical disks [trayID1,slotID1 ... trayIDn,slotIDn]) serviceAllowedIndicator=(on | off)
Parameters
Parameter Description physical disk or physical disks
Identifies the enclosure and slot where the physical disk resides. Enclosure ID values are 0 to 99. Slot ID values are 1 to 32. Enclose the enclosure ID and slot ID values in square brackets ([ ]). serviceAllowedIndicator
Defines whether the Service Action Allowed indicator light is turned on or turned off. To turn on the Service Action Allowed indicator light, set this parameter to on. To turn off the Service Action Allowed indicator light, set this parameter to off. Notes
This command was originally defined for use with the FC-4 16x expansion enclosure. This command is not supported by expansion enclosures that were shipped before the introduction of the FC-4 16x expansion enclosure.
Minimum Firmware Level
6.16