This command turns on or turns off the Service Action Allowed indicator light on a RAID controller module in a RAID controller module enclosure or a storage system. If the storage array does not support the Service Action Allowed indicator light feature, this command returns an error. If the storage array supports the command but is unable to turn on or turn off the indicator light, this command returns an error. (To turn on or turn off the Service Action Allowed indicator light on the power-fan module or the interconnect-battery module, use the set enclosure serviceAllowedIndicator command.)
set RAID controller module=[(a | b)] serviceAllowedIndicator=(on | off)
| Parameter | Description |
|---|---|
|
RAID controller module |
The RAID controller module that has the Service Action Allowed indicator that you want to turn on or turn off. Valid RAID controller module identifiers are a or b, where a is the RAID controller module in slot A (the top RAID controller module), and b is the RAID controller module in slot B (the bottom RAID controller module). Enclose the RAID controller module identifier in square brackets ([ ]). If you do not specify a RAID controller module, the RAID controller module firmware returns a syntax error. |
|
serviceAllowedIndicator |
This parameter defines whether the Service Action Allowed indicator is turned on or turned off. To turn on the Service Action Allowed indicator light, set this parameter to on. To turn off the Service Action Allowed indicator light, set this parameter to off. |
This command was originally defined for use with the E6000 RAID controller module enclosure. This command is not supported by RAID controller module enclosures that were shipped before the introduction of the E6000 RAID controller module enclosure.
6.14