Save Storage Array Diagnostic Data
This command saves the diagnostic data for a storage array to a file. You can review the file contents at a later time. You can also send the file to a Customer and Technical Support representative for further review. After you have saved the diagnostic data, you can reset the NVSRAM registers that contain the diagnostic data so that the old data can be overwritten. Use the reset storageArray diagnosticData command to reset the diagnostic data registers.
Important: Run this command only with the assistance of a Customer and Technical Support representative.
Syntax
save storageArray diagnosticData [(RAID controller module | esm)] file="filename"
Parameters
Parameter Description RAID controller module This parameter downloads the diagnostic data from the RAID controller modules. esm This parameter downloads the diagnostic data from the EMMs. file
The name of the file to which you want to save the diagnostic data. Enclose the file name in double quotation marks (" "). Minimum Firmware Level
6.16