Reset Storage Array Battery Install Date

This command resets the age of the batteries in a storage system to zero days. You can reset the batteries for an entire storage system or just the battery for a specific RAID controller module or in a specific battery pack.

Syntax

reset storageArray batteryInstallDate (RAID controller module=[(a | b)] | batteryPack [left | right])

Parameters

Parameter	Description
RAID controller module	The RAID controller module that contains the battery for which you want to reset the age. Valid RAID controller module identifiers are a or b, where a is the RAID controller module in slot A, and b is the RAID controller module in slot B. Use the RAID controller module parameter only for RAID controller modules with batteries.
batteryPack	The battery pack contains both a left battery and a right battery. Valid identifiers are left or right, where left is the battery that supports the RAID controller module in slot A, and right is the battery that supports the RAID controller module in slot B. Use the batteryPack parameter only for RAID controller module enclosures with battery packs.

Notes

If the command statement uses the wrong parameter, an error appears.

Minimum Firmware Level

6.10

7.30 adds the ability to reset the battery installation dates on specific batteries that are inside the RAID controller module enclosure.