Reset RAID Controller Module

This command resets a RAID controller module.

Important: When you reset a RAID controller module, the RAID controller module is not available for I/O operations until the reset is complete. If a host is using virtual disks owned by the RAID controller module being reset, the I/O directed to the RAID controller module will be rejected. Before resetting the RAID controller module, either verify that the virtual disks owned by the RAID controller module are not in use or ensure a multi-path driver is installed on all hosts using these virtual disks.

Syntax

reset RAID controller module [(a | b)]

Parameters

Parameter	Description
(a | b)	The RAID controller module that you want to reset. Valid RAID controller module identifiers are a or b where a is the RAID controller module in slot A and b is the RAID controller module in slot B. Enclose the RAID controller module identifier in square brackets ([ ]). If you do not specify an owner, the RAID controller module firmware returns a syntax error.

Minimum Firmware Level

5.20