Add/Configure SNMP Trap

The Add SNMP Trap and Configure SNMP Trap windows are identical. Use these windows to perform the following tasks:

Enable an SNMP trap
Specify the destination IP address for the trap
Specify the events and their corresponding severities required to trigger a trap from the RAC

NOTE: Server Administrator supports three severity levels: Informational, Warning, and Severe. Some events support only the informational severity level because they deliver only a message.

System Tree Selection	Tab	Subtab	Button or Link	User Privileges
				View	Manage
Main System Chassis
Remote Access Controller	Configuration	SNMP	Add or a Destination IP Address entry	A	A

U=User; P=Power User; A=Administrator; NA=Not Applicable. For more details on user privilege levels, see "Privilege Levels in the Server Administrator GUI."

[Back to Top]

Add/Configure SNMP Trap Controls

Remove		Removes the current trap.
General		Takes you to the General configuration controls.
Severity Configuration		Takes you to the Severity Configuration controls.
General
Enable SNMP Trap		Enables the current trap.
	Community	Specifies or edits the community name to which the destination IP address belongs.
	IP Address	Specifies or edits the destination IP address to which the trap is sent.
Severity Configuration
	Informational	Triggers the current trap if the RAC generates the corresponding event (listed under Trap Description) at a severity level of Informational.
	Warning	Triggers the current trap if the RAC generates the corresponding event (listed under Trap Description) at a severity level of Warning.
	Severe	Triggers the current trap if the RAC generates the corresponding event (listed under Trap Description) at a severity level of Severe.
Trap Description		Lists the events, or "lower-level traps," that the RAC can generate.
Go Back To SNMP Traps Page		Returns you to the Configure SNMP Traps window.
Apply Changes		Adds a new trap or commits changes made to the current trap.

[Back to Top]