Set Enclosure Alarm

This command turns on, turns off, or mutes the audible alarm for a specific enclosure or all enclosures in a storage array.

Syntax

set (allEnclosures | enclosure [trayID] alarm=(enable | disable | mute))

Parameters

Parameter Description
allEnclosure This parameter selects all enclosures in a storage array that have audible alarms that you want to turn on, turn off, or mute.
enclosure This parameter identifies a specific enclosure that has the audible alarm that you want to turn on, turn off, or mute. Enclosure ID values are 0 to 99. Enclose the enclosure ID value in square brackets ([  ]).

alarm

This parameter defines the settings for the audible alarm and has the following arguments:

  • enabled - The audible alarm is turned on and sounds if a fault occurs.
  • disabled - The audible alarm is turned off and does not sound if a fault occurs.
  • mute - The audible alarm is turned off if it is sounding.

(If another fault occurs after you set the audible alarm to mute, the audible alarm sounds again.)

Minimum Firmware Level

6.16