Set Host Channel

Set Host Channel

This command defines the loop ID for the host channel.

Syntax

set hostChannel [hostChannelNumber] preferredID=portID

Parameters

Parameter Description

hostChannel
The identifier number of the host channel for which you want to set the loop ID. Enclose the host channel identifier number in square brackets ([ ]).
For all command modules other than the E6000 series command modules, valid host channel values are a1, a2, b1, b2.

For the E6000 series command modules, valid host channel values are a1, a2, a3, a4, b1, b2, b3, b4.

portID
The new port ID for the specified host channel. Port ID values are 0-127.

Minimum Firmware Level

6.10

Parameter	Description
`hostChannel`	The identifier number of the host channel for which you want to set the loop ID. Enclose the host channel identifier number in square brackets ([ ]). For all command modules other than the E6000 series command modules, valid host channel values are `a1`, `a2`, `b1`, `b2`. For the E6000 series command modules, valid host channel values are `a1`, `a2`, `a3`, `a4`, `b1`, `b2`, `b3`, `b4`.
`portID`	The new port ID for the specified host channel. Port ID values are 0-127.