Show RAID Controller Module

For each RAID controller module in a storage array, this command returns:

• Status (online, offline)
• Current firmware and NVSRAM configuration
• Pending firmware and NVSRAM configuration configurations (if any)
• Board ID
• Product ID
• Product revision
• Serial Number
• Date of manufacture
• Cache/processor size
• Date/time to which the RAID controller module is set
• Associated virtual disks (including perferred owner)
• Ethernet port
• Physical disk interface
• Host interface (this applies only to Fibre Channel host interfaces)

Syntax

show (allRAID Controller Modules | RAID controller module [(a | b)]) [summary]

Parameters

Parameter	Description
allRAID Controller Modules	Returns information about both RAID controller modules in the storage array.
(a | b)	Returns information about a specific RAID controller module in the storage array. Valid RAID controller module identifiers are a or b where a is the RAID controller module in slot A and b is the RAID controller module in slot B. Enclose the RAID controller module identifier in square brackets ([ ]).
summary	Returns a concise list of information about both RAID controller modules in the storage array.

Notes

The following list is an example of the information returned by the show RAID controller module command. This example is used only to show how the information is presented and should not be considered to represent best practice for a storage array configuration.

When you use the summary parameter, the command returns the list of information without the physical disk channel and host channel information.

The detailed RAID controller module information is also returned for the show storageArray command.

Minimum Firmware Level

summary parameter 5.43