Reset Storage Array Diagnostic Data

This command resets the NVSRAM that contains the storage array diagnostic data. This command, however, does not delete the diagnostic data. This command replaces the Needs Attention status with Diagnostic Data Available status. The old diagnostic data is then automatically written over when new data is captured. The memory that contains the diagnostic data is also cleared when the RAID controller modules reboot. Before resetting the diagnostic data, use the save storageArray diagnosticData command to save the diagnostic data to a file.

Important: Run this command only with the assistance of a Customer and Technical Support representative.

Syntax

reset storageArray diagnosticData

Parameters

None.

Minimum Firmware Level

6.16